MerCruiser 46734A1 Gimbal Bell Housing Pre-Alpha One 1969-1971 Early W/O Senders

Move your mouse over image or click to enlarge

IF YOUR GIMBAL HOUSING HAS TRIM SENDERS THIS IS NOT THE RIGHT BELL HOUSING

Part Numbers:

Bell Housing Assembly: 46734A1 (stamped 46734) Replaced by 68417A1
- It will generally be the best practice to try and match the number stamped in your current bell housing.
- There is some minor but heavy pitting by the water inlet passage. I have looked very closely at this and with a new o-ring, there should not be any issue with this area sealing properly.
- This is for MerCruiser applications 1969-1971ish (usually used on applications up until serial number 3443920 & below) as it is the early style that has a few unique features and is the first style without the lever on the side of it.
  - ****Uses the EARLY non-grooved bellows assembly (MerCruiser 36223A1)****
  - For gimbal rings that DO NOT have trim senders covering the pivot pins...
    - The pivot pins used with this type of bell housing were steel dowels held in by nails rather than having threaded ends that screwed in.
- Also Note... This has been updated (re-tapped) to accept the newer standard style of shift cable with REAR/AFT installation into the bell housing assembly (19543A4) You may have to swap out some components on the reverse lock system to accept this newer type of cable.

Compatibility

This was used from 1969-1971ish (probably only the earlier part of that timespan)
- Again, if your Gimbal Housing has trim senders.. this is not the right one.
Found on these Models:
- 2.5L 120hp I-4cyl GM (1969-1971)
- 3.0L 140hp I-4cyl GM (1969-1971)
- 4.1L 160hp I-6cyl GM (1969)
- 4.1L 165hp I-6cyl GM (1970-1971)
- 888 188hp V8 5.0L 302 Ford (1971)

Item Details

Purchase with confidence!

1968 1969 1970 1971